2006 Arctic Cat DVX Utility 250 Service Manual, Page 117Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 117

3Remove the nut securing the hub4Remove the cap screws securing the brake caliper; then remove the caliper and lay aside
then remove the front bumperCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
replacement is necessary 6Remove the cotter pin and slotted nut securing the tie rod end to the knuckle; then remove the
tie rod end from the knuckle 1Clean the knuckle in parts-cleaning solvent; then dry with compressed airIf any damage or excessive
wear is detected, the knuckle must be replaced2Inspect the ball joint for boot damage or wearReplace the A-arm if the ball