2006 Arctic Cat DVX Utility 250 Service Manual, Page 127Get this manual

2006 Arctic Cat DVX Utility 250 Service Manual, Page 127

4Install the six cap screws securing the body to the top of the frameTighten securely5Install the fuse block, start-in-gear
connectors; then install the shift knob3Making sure the locating tabs engage the appropriate slots in the fenders, install
the side panels 7Install the battery cover; then install the seat making sure it locks securely in place Steering Post CoverInstrument
Pod REMOVING (DVX Model) 1Remove the two reinstallable rivets on the rear of the steering post cover; then lift up and push
the assembly forward to remove2Disconnect the wire connectors from the indicator lights and from the ignition switchKM340A
4Install the mud guards and secure to the fenders and foot rest supports with the existing hardwareMake sure all locating
tabs are appropriately engaged with the fenders and side panels REMOVING (Utility Model) 1Remove the reinstallable rivet
on the front of the instrument pod and the two cap screws on the rear; then lift the assembly off and disconnect the speedometer