2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 13Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 13

5Tighten the jam nut to secure the adjustment; then slide the rubber boot back into position Adjusting Engine RPM To properly
short distance6Turn the engine off and wait approximately one minuteRemove the filllevel plug and recheck the lubricant levelThe
level should be visible at the level holeIf lubricant is not visible, add recommended lubricant until the level is visible
at the level hole7Inspect the area around the drain plug for leaks ! WARNING Adjust the idle to the correct RPMMake sure
the engine is at normal operating temperature before adjusting the idle RPM Transmission Lubricant 1Park the ATV on level
ground2Remove the filllevel plug from the left-rear of the transmissionBe careful not to allow contaminates to enter the
opening Engine Oil 1Move the ATV outdoors and start and warm up the engineShut the engine off; then place drain pan under