2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 20Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 20

3Pinch the drive belt together near its center and slide the stationary drive sheave over the crankshaftInstall the washer,
remove the drive belt INSTALLING 1If removed, place the gasket and two alignment pins into position on the crankcase2Spread
the faces of the driven clutch with suitable pry bar or wedge; then when the faces are separated, insert the drive belt 4Rotate
the drive belt and sheaves until the drive belt is flush with the top of the driven clutch 5Place the drive clutch cover