2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 44Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 44

6Install two O-rings, one alignment pin, and the oil pump on the right-side crankcse half; then secure with three cap screws
7Install the oil pump gear with the flange nutTighten the nut to specifications 10Install the eight cap screws to the right-side
crankcase coverApply red Loctite #271 on the cap screws and tighten to specificationsNOTE: Note the correct position for
the different-lengthed cap screws that they are installed in the proper locations ! CAUTION Take care that the flat in the
oil pump gear hub is aligned with the flat on the oil pump shaft or damage to the gear and shaft will occur DSC02234 DSC02227
11Install the stator in the right-side crankcase cover; then install the two cap screws (coated with red Loctite #271)Tighten