2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 70Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 70

3Crank the engine over using the electric starterThe meter must read 190-282 volts Battery ! CAUTION The battery can be permanently
16.0-19.5 voltsRESISTANCE ! WARNING Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals
known to the state of California to cause cancer and reproductive harmWash hands after handling CHARGING 1Set the meter selector
to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black tester lead to the white wire3The
meter must less than ohm 1Remove the battery from the ATV ! WARNING Remove the negative cable first; then remove the positive
cable ! CAUTION Do not charge the battery while it is in the ATV with the battery terminals connected Choke Circuit Disconnect
the white two-pin connector adjacent to the steering postCHOKE VOLTAGE NOTE: The battery must be at full charge for this
test 2Trickle-charge the battery at 1.5 amps for 8-10 hours ! CAUTION Before installing the battery, make sure the ignition