2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 72Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 72

NOTE: If the meter does not read as specified, replace ignition coil 2Set the meter selector to the OHMS position3Connect
SPARK PLUG CAP RESISTANCE 1Connect the red tester lead to one end of the cap; then connect the black tester lead to the other
end of the cap2The meter must read 4725-5775 ohmsNOTE: If the meter does not read as specified, replace the spark plug cap
Handlebar Control Switches The connector is in front of the steering postThe connector is accessible beneath the front fenderNOTE:
These tests should be made on the switch side of the connector Ignition Switch The connector is accessible below the front
fender panel in front of the steering postVOLTAGE NOTE: Perform this test on the harness side of the connector ! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the meter selector to
the DC Voltage position2Connect the red meter lead to the red wire; then connect the black meter lead to suitable ground3Meter