2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 73Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 73

2Connect the red tester lead to the blueyellow wire; then connect the black tester lead to the green wire3With the switch
battery cable from the battery first; then disconnect the positive cable ! CAUTION Always disconnect the negative battery
cable from the battery first; then disconnect the positive cable 2Remove the flywheel from the engine (see Section 3)3Remove
the stator and timing sensor from the stator plate 2Remove the starter motor from the engine (see Section 3)3Remove the nut
securing the positive cable to the starter; then remove the cable from the starterAccount for an O-ringINSTALLING Install
the starter motor (see Section 3) RegulatorRectifier The regulatorrectifier is located near the batteryVOLTAGE KEY 1234 1Set
the meter selector to the DC Voltage positionFlange Bolt Cooling Fan Flange Nut Flywheel 5Flange Bolt 6Bolt 7Stator 740-502A
2Test between the black and white wires (with the regulatorrectifier plugged in) INSPECTING 1Check stator for signs of overheating,