2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 81Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 81

REMOVING REAR SPROCKET 1Secure the ATV on support stand to elevate the right rear wheel ! WARNING Make sure the ATV is solidly
rear sprocketAccount for four O-rings on the master link 1With the chain installed and with the rear brake applied, remove
the two cap screws securing the sprocket to the countershaftAccount for washer2Remove the drive chain (see Removing Drive
Chain in this sub-section)3Remove the countershaft sprocketAccount for washerINSTALLING FRONT (COUNTERSHAFT) SPROCKET 1Place
the countershaft sprocket over the countershaft2Install the drive chain (see Installing Drive Chain in this sub-section)3Install
the washer and two cap screws4With the rear brake lever lock applied, tighten the cap screws to specifications NOTE: It is