2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 82Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 82

4Install the drive chain (see Installing Drive Chain in this sub-section)5Install the chain guard and secure with two cap
injury 1Position the sprocket onto the sprocket carrier; then install the three cap screws securing the sprocket to the sprocket
carrierTighten the cap screws to specifications2Slide the rear sprocket carrier and rear sprocket onto the axle and into
position next to the axle housing 2Remove the cotter pins from the castle nuts on the rear wheel hubs3Remove the rear wheel
hub castle nuts; then slide the rear wheels and hubs off togetherAccount for the washers4Remove the drive chain (see Removing
Drive Chain sub-section)5Remove the rear sprocket (see steps 5-8 of Removing Rear Sprocket sub-section)6Remove the drive
axle by sliding it out the right side of the axle housingNOTE: Note the difference in the length between the four sets of