2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 83Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 83

REMOVING AXLE HOUSING 1Secure the ATV on support stand to elevate the rear wheels ! WARNING Make sure the ATV is solidly
SEALS 1Secure the ATV on support stand to elevate the rear wheels 3Remove drive chain, wheels, hubs, spacers, and axle as
necessary (see Removing Rear HubDrive Axle in this sub-section)NOTE: Do not remove more components than necessary to perform
the intended serviceThe axle housing will separate from the swing arm with all components attached if necessary ! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the wheels and hubs (see Removing Rear
HubDrive Axle in this sub-section)3Using an appropriate prying tool, carefully pry out the seals from each side of the axle
housing 4Remove the four cap screws (A) securing the axle housing to the swing arm; then remove the axle housing KM217B KM232