2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 84Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 84

NOTE: It may be helpful to insert the axle through the previously installed bearing and into the axle housing to align the
it on flat surface and checking for wobble7Inspect axle housing for dents or warpage that might interfere with bearing bore
or alignmentINSTALLING BEARINGS AND SEALS INSTALLING AXLE HOUSING 1Position axle housing in swing arm; then install and finger-tighten
the four cap screws securing the axle housing to the swing arm2Install the brake caliper to the axle housing 1Using plastic
mallet and bearing driver or appropriate size socket, carefully install the first bearing into the axle housingKM207 3Install
the drive chain (see Installing Drive Chain sub-section)4Adjust the drive chain slack (see Adjusting Drive Chain sub-section);
then tighten the four cap screws (from step 1) to specificationsINSTALLING DRIVE AXLEREAR HUB 1Slowly slide the axle into
the axle housingKM226 2Place the center axle housing spacer in the axle housing; then using plastic mallet, install the second