2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 90Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 90

2Inspect each shock rod for nicks, pits, rust, bends, and oily residue3Inspect all springs, spring retainers, shock rods,
stand to elevate the front wheel; then remove the wheel ! CAUTION Do not tighten the nuts beyond the 4.0 kg-m (29 ft-lb)
specification or the shock eyelet or mount WILL be damaged ! WARNING Make sure the ATV is solidly supported on the support
stand to avoid injury 3Remove the ATV from the support standINSTALLING REAR SHOCK ABSORBER 2Remove the cotter pin, castle
nut, and washer; then remove the hub assembly 1Place the spring preload adjuster and spring over the shock absorberCompress
the spring and install the retainer2Place the shock absorber into position on the frame and swing arm and install the two