2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 93Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 93

7Remove the ATV from the support stand ! WARNING After removing and installing components that are brake-related, ALWAYS
and rear chain guard; then remove the skid plate and rear chain guard 3Remove drive chain, hubs, spacers, and axle as necessary
(see Rear HubDrive Axle in Section 6)NOTE: Do not remove more components than necessary to perform the intended serviceThe
axle housing will separate from the swing arm with all components attached if necessaryMD2014 6Remove the cap screw securing
the shock absorber to the swing arm 4Remove the four cap screws (A) securing the axle housing to the swing arm; then remove