2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 96Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 96

CHECKINGINFLATING 1Using an air pressure gauge, measure the air pressure in each tireAdjust the air pressure as necessary
or bends4Inspect each tire for cuts, wear, missing lugs, and leaksINSTALLING 3Test drive the ATV on dry, level surface and
note any pulling to the left or right during acceleration, deceleration, and brakingNOTE: If pulling is noted, measure the
circumference of the front and rear tires on the pulling sideCompare the measurements with the tires on the opposite sideIf
pulling is noted during braking only, check and adjust the brakes as necessary and recheck operation (see Section 2) 1Install
each wheel on its hubNOTE: Make sure each wheel is installed on its proper hub as noted in removing (the "rotation arrow"
must indicate forward direction of rotation) 4Increase the air pressure in the tires with the smallest circumference measurement