2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 100Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 100

1Wash the tie rod ends in parts-cleaning solventDry with compressed airInspect the pivot area for wearApply low-temperature
for cracks, wear, or unusual bendsINSTALLING 4Route the control cables and wiring through the metal loop on the steering
post 1Place the steering post into positionTighten the two nuts on the outer bearing cap making sure the two-piece plastic
bearing is in placeTighten the nuts to specificationsMD2135 5Install the front fender panel and gas tank cap 2Install the
steering post nut and tighten to specificationsInstall new cotter pin 6Install handlebar with alignment pins in lower clamps