2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 104Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 104

Handlebar Grip REMOVING 1Using compressed air nozzle and low pressure, peel up the inner corner of the grip2Apply air pressure
the grip for deteriorationINSTALLING NOTE: Before installing handlebar grip, use contact spray or alcohol to clean the inside
of the grip and the handlebar of glue residue, oil, or any other contaminant 6Place the hub assembly onto the spindle; then
install the washer and castle nutTighten the castle nut to specifications; then install new cotter pinInstall the wheels
and tighten the cap screws to specifications7Remove the ATV from the support stand ! WARNING After removing and installing
of components that are brake-related, ALWAYS check and adjust brakes as necessary before operating the ATV 1Apply liberal