2007 Arctic Cat 700 Diesel ATV Service Manual, Page 15Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 15

TAILLIGHT-BRAKELIGHT To replace the taillight-brakelight bulb, use the following procedure1Turn the bulb socket counterclockwise
geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming1Position the ATV on level floor
so the headlights are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)NOTE: There should
be an average operating load on the ATV when adjusting the headlight aim Switches Each time the ATV is used, switches should
be checked for proper operationUse the following list for referenceAIgnition switch engine will startBEmergency stop switch
engine will stopCReverse switch reverse indicator light will illuminateDHiLo switch headlight beam bright and dimEBrake switches
rear brakelight will illuminate 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements