2007 Arctic Cat 700 Diesel ATV Service Manual, Page 21Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 21

6Place the V-belt cover gasket into position; then install the cover and secure with the cap screwsTighten to specifications
screwsTighten securely8Install the right-side footrest (see Section 8) Adjusting Differential Lock Cable If the differential
or differential lock system has been serviced, the differential lock cable should be checked andor adjusted for proper free-playTo
adjust the cable, use the following procedure1With the differential lock selector in the UNLOCK position, slide the rubber
boot (A) off the adjuster; then loosen the jam nut (B)Turn the adjuster (C) to achieve 6.35 mm (0.250 in of free-play measured
at the end of the differential lock lever 3Depress and release the manual primer pump to charge the fuel filter and purge
any air from the system 2Select the 2WD position on the front drive selector switch; then turn the ignition switch to the
ON position and select the LOCK position on the differential lock selectorThe front drive actuator should operate engaging