2007 Arctic Cat 700 Diesel ATV Service Manual, Page 28Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 28

TRANSMISSION NOTE: The transmission can be removed for servicing without removing the engineTo remove the transmission, use
shift position switch connector, speed sensor connector, and shift linkage6Remove the V-belt (see Section 2)7Remove the nut
securing the driven pulley to the transmission input shaft; then remove the driven pulleyAccount for flat washer, square
key, and four shims 22Move the enginetransmission slightly forward and shift the rear propeller shaft to the right; then
rotate the rear of the assembly out of the left sideNOTE: The front engine mount bracket and fuel filter housing can be removed
to allow more clearance at the front of the engine 23Remove the front propeller shaft from the transmission output yoke;
then slide the enginetransmission out the left side lifting the transmission to tilt the engine sufficiently forward for