2007 Arctic Cat 700 Diesel ATV Service Manual, Page 35Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 35

CAMSHAFTROCKER ARMS Removing 1Remove the timing belt (see Left-Side Components in this section)2Remove the front rack and
installing the valve coverThe valve cover gasket is critical component in the lubrication systemSevere engine damage may
occur if the gasket is not replacedDE516A 3Use duct tape to cover the engine air intake boot to prevent dirt or debris from
entering the engine4Disconnect the oil pressure switch connector from the switch located on the right side of the valve cover;
then remove the fuel lift pump (see Lift Pump in Section 4) 12Install the air filter assembly and connect and secure all