2007 Arctic Cat 700 Diesel ATV Service Manual, Page 58Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 58

2Make sure the cylinder deck surface is clean and free of all oil, grease, varnish, or coolant 5Clean the threads of the
from the cylinder head bolt bores; then using an appropriate tap, clean the threads 8In the same pattern, tighten each cylinder
head bolt 90; then tighten an additional 90 using the same pattern ! CAUTION Failure to remove oil or coolant from bolt bores
may result in hydraulic lock when installing head boltsThis will cause severe engine block damage 4Place the cylinder head
gasket onto the cylinder deck aligning the gasket on the alignment pins; then carefully install the cylinder head onto the