2007 Arctic Cat 700 Diesel ATV Service Manual, Page 63Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 63

NOTE: The keyway in the crankshaft MUST be in the 12 o'clock position before attempting to remove the oil pump AT THIS POINT
for keyDE238 5Thoroughly clean the seal bore making sure it is free of all oil and sealant and free of any nicks or burrs6Soak
new oil seal in clean engine oil for approximately 30 minutes; then using an appropriate driver, drive the seal into the
oil pump housing until flush with the outer seal bore 3Remove the screws securing the oil pump to the engine block; then
tap lightly on the oil pump with plastic mallet to loosen the gasket and remove the oil pump assembly from the crankshaftDE237
NOTE: If there is groove worn in the crankshaft where the seal contacts, press the seal into the bore an additional mm (.080