2007 Arctic Cat 700 Diesel ATV Service Manual, Page 64Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 64

Installing 1Clean all gasket material from the surface of the engine block2Make sure the oil pump drive key in the crankshaft
pulley8Install the timing belt (see Left-Side Components in this section)ALTERNATORREGULATOR 3Install two alignment bolts
in the engine block; then install new oil pump gasket into position on the engine block Removing 1Remove the negative battery
cable from the battery; then remove the seat and left-side engine cover2Disconnect the battery (B+) wire from the alternator;
then disconnect the voltage regulator control plug-in 4Lubricate the crankshaft and crankshaft seal with liberal amount of
engine oil; then install the oil pump onto the crankshaft being careful not to damage the oil sealNOTE: It may be necessary
to rock the oil pump slightly from side-to-side to engage the keyway completely onto the key3-42 3Loosen the alternator adjuster