2007 Arctic Cat 700 Diesel ATV Service Manual, Page 65Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 65

3Holding tension on the belt, tighten the adjuster cap screw securely; then remove the pry and tighten the pivot bolt securely4Connect
be replaced as an assembly NOTE: The enginetransmission does not have to be removed from the frame for this procedure AT
THIS POINT If the technician's objective is to serviceinspect the V-belt cover, driven pulley, or drive clutch, see Section
2 Installing 1Place the alternatorregulator into position on the engine; then secure with the existing hardwareDo not tighten
at this time2Place the alternator drive belt into position; then using suitable pry, tension the drive belt so that 10 kg
(22 lb) force applied at the midway point will result in deflection of 10-15 mm (0.4-0.6 in FLYWHEELPTOV-BELT HOUSING Removing
1Remove the transmission (see Removing EngineTransmissionTransmission in this section)2Using Drive Clutch Puller (pn 0444-226),