2007 Arctic Cat 700 Diesel ATV Service Manual, Page 69Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 69

10Remove the output driveshaft assembly (A)Account for the bearing alignment C-ring in the bearing boss next to the output
shift fork12Remove the shift shaft (C) and account for two thrust bearing races, one thrust bearing, and two washers NOTE:
The thrust washers on the reverse idler gear are identical AT THIS POINT 13Remove the lowreverse shift fork; then remove
the input driveshaft (D)NOTE: The shift forks are identical; therefore, they may be used in either locationHowever, it is
advisable to return mating parts to their original positions during assembling If the drive bevel gear assembly (G), bearings,