2007 Arctic Cat 700 Diesel ATV Service Manual, Page 70Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 70

16Heat the retaining nut on the secondary output shaft; then holding the gear assembly securely, remove the retaining nutAccount
the output drive bearing in the right-side case; then using appropriate bearing drivers, remove the appropriate bearings
20Remove the retaining nut from the front driveshaft and remove the front drive yokeAccount for washer, seal, bearing, and
shim 21Remove the retaining nut from the rear driveshaft and remove the rear drive output couplerAccount for washer, bearing,
and seal Disassembling Driveshaft Drive Bevel Assembly NOTE: Steps 1-18 of the preceding sub-section must precede this procedure