2007 Arctic Cat 700 Diesel ATV Service Manual, Page 76Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 76

The countershaft is now assembled and ready for installation AT THIS POINT If the drive bevel gear assembly or secondary
and tighten to specificationsStake the retaining nut to the shaftDE147 12Install the rear drive gear bearing, oil seal, and
output drive flange to the rear of the output driven shaft; then secure with washer and nutTighten to specifications and
stake the nut DE145A DE149A 11Install shim, front driven shaft bearing, driven shaft seal, and yoke on the front of the output
driven shaft; then secure with washer and nutTighten to specifications and stake the nut to the shaft NOTE: The drive bevel