2007 Arctic Cat 700 Diesel ATV Service Manual, Page 84Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 84

CCompare the final piston protrusion (Ppf) to the chart to determine if gaskets are available that would allow planing of
that no gasket would be available to allow sufficient piston-to-cylinder head clearance; therefore the engine block must
be replaced DIf engine block is not serviceable, it must be replaced with new block6Thoroughly clean the engine block using
non-caustic engine cleaning solution; then rinse with hot water and dry with compressed air ! WARNING Always wear safety
glasses when using compressed air NOTE: Planing the engine block is not recommended as it will directly affect piston-to-cylinder
head clearanceTo determine if the cylinder deck can be planed, use the following procedure 7Using cylinder bore gauge or
suitable snap gauge and micrometer, measure the cylinder bore at three locations taking measurements at 45 intervalsIf the
cylinder is found to be 72.050 mm (2.836 in or greater at any measurement point, the cylinder(s) must be boredOversized pistonsrings