2007 Arctic Cat 700 Diesel ATV Service Manual, Page 90Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 90

6Using 0.07 mm (0.003 in shim stock as shown, slide the main bearing cap into position in the main bearing saddle being
certain that no binding exists11If pistons were removed from connecting rods, install the pistons onto the connecting rods
making sure the piston pin retainer clips are properly seated and the open ends are orientated facing downward 8Install the
center main bearing cap and finger tighten the cap screwsDE371A 12Check piston ring gap by installing the ring in the cylinder