2007 Arctic Cat 700 Diesel ATV Service Manual, Page 106Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 106

1Remove the seat2Remove the rear rack and fenders (see Section 8)3Disconnect the hose from the fuel tank to the lift pump;
the inner fender splash panel, right-side engine cover, and seatMake sure the seat latches securely NOTE: If any "pin-holes"
are noted in the fuel screen, replace the fuel level sensor assembly 5Inspect the tank cap and filler neck for chipped or
broken threads6Inspect the fuel tank mountings for security, signs of cracking, or wearing through the tank7Inspect all fuel
and vent hoses for cracks, softening, or deteriorationReplace as requiredINSTALLING 1Place the fuel tank into position in
the frame; then install the cap screwsTighten securely2Connect the fuel hose from the lift pump; then connect the fuel gauge
connector3Install the vent hose and fuel return hose; then fill the fuel tank with diesel fuel4Pump the manual primer pump
12-20 strokes; then start the engine and inspect for leakage5Install the rear fenders and rack (see Section 8); then install
the seat making sure it latches securely Throttle Cable Free-Play To adjust throttle cable free-play, see Section 2 Fuel