2007 Arctic Cat 700 Diesel ATV Service Manual, Page 108Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 108

2Remove the cap from the filler neck and slowly pour the recommended amount of coolant into the system3Move the ATV outside
1Position the fanfan shroud assembly on the radiator; then secure with existing hardware2Place the radiator with grommets
and collars into position on the frame; then install the cap screws and nutsTighten securely3Install the upper and lower
coolant hoses; then secure with hose clamps ! WARNING Do not over-tighten coolant filler cap or excess pressure will build
up in the cooling system causing cooling system damage and possible bodily harm Radiator REMOVING 1Drain the coolant at the
engine2Remove the front rack (see Section 8)3Remove the front bumper and front fender panel (see Section 8)4Remove the upper
and lower coolant hoses5Remove the cap screws and nuts securing the radiator to the frame6Disconnect the fan wiring from
the main wiring harness; then remove the radiatorfan assembly and account for the grommets and collars7Remove the fanfan