2007 Arctic Cat 700 Diesel ATV Service Manual, Page 112Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 112

VOLTAGE (Wiring Harness Side) Battery For battery related information, see Section 2 1Set the meter selector to the DC Voltage
shows battery voltage, the main wiring harness is good; proceed to test the switchcomponent, the connector, and the switch
wiring harness for resistance Accessory ReceptacleConnector NOTE: This test procedure is for either the receptacle or the
connector RESISTANCE (Switch Connector) ! CAUTION Always disconnect the battery when performing resistance tests to avoid
damaging the multimeter VOLTAGE 1Turn the ignition switch to the ON position; then set the meter selector to the DC Voltage
position2Connect the red tester lead to the redwhite wire or the positive connector; then connect the black tester lead to
ground3The meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, receptacle,
connector, or the main wiring harness 1Set the meter selector to the OHMS position2Connect the red tester lead to one black
wire; then connect the black tester lead to the other black wire Brakelight Switch (Auxiliary) The switch connector is the