2007 Arctic Cat 700 Diesel ATV Service Manual, Page 115Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 115

2Select the OHMS position on suitable tester; then connect one tester lead to suitable ground and the other tester lead
the black tester lead to ground3The meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot
the battery, fuse, motor, or the main wiring harnessNOTE: If the meter shows battery voltage, the main wiring harness is
goodThe connector should be checked for resistance Fuse BlockPower Distribution Module The fuses are located in power distribution
module under the seatIf there is any type of electrical system failure, always check the fuses firstNOTE: The ignition switch
must be in the LIGHTS position 1Remove all fuses from the distribution module2Set the meter selector to the DC Voltage position3Connect
the black tester lead to ground4Using the red tester lead, contact each end of the fuse holder connector terminals individually5The
meter must show battery voltage from one side of the connector terminal endsNOTE: Battery voltage will be indicated from