2007 Arctic Cat 700 Diesel ATV Service Manual, Page 116Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 116

NOTE: When testing the HI fuse holder, the headlight dimmer switch must be in the HI position; when testing the LIGHTS fuse
housing2Remove the sensor from the sensor housing accounting for an O-ring 1Set the meter selector to the OHMS position2Connect
the red tester lead to one spade end of the fuse; then connect the black tester lead to the other spade end3The meter must
show less than ohm resistanceIf the meter reads open, replace the fuseNOTE: Make sure the fuses are returned to their proper
position according to amperageRefer to the fuse block cover for fuse placement Electronic Speedometer Speed Sensor NOTE:
Prior to testing the speed sensor, inspect the three-wire connector on the speed sensor for contamination, broken pins, andor
corrosion 3Install the new speed sensor into the housing with new O-ring lightly coated with multi-purpose grease; then secure
the sensor with the Allen-head cap screw (threads coated with blue Loctite #242)Tighten securely 1Set the meter selector