2007 Arctic Cat 700 Diesel ATV Service Manual, Page 117Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 117

Ignition Switch The connector is four-wire oneTo access the connector, the cover must be removedVOLTAGE NOTE: Perform this
1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black tester
lead to the gray wire3With the dimmer switch in the HI position, the meter must show less than ohmNOTE: If the meter shows
more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness ! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter NOTE: Perform this test on
the upper side of the connector 1Turn the ignition switch to the ON position2Set the meter selector to the OHMS position3Connect
the red tester lead to the red wire; then connect the black tester lead to the redblack wire4The meter must show less than
ohm5Turn the ignition switch to the LIGHTS position6Connect the red tester lead to the red wire; then connect the black tester