2007 Arctic Cat 700 Diesel ATV Service Manual, Page 118Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 118

3With the starter button depressed, the meter must show 0.5-0.7 DC volts4With the starter button released, the meter must
harness, connector, 30 amp fuse, and battery connections RESISTANCE (Emergency Stop) 1Set the meter selector to the OHMS
position2Connect the red tester lead to the orange wire; then connect the black tester lead to the orangewhite wire3With
the switch in the OFF position, the meter must show an open circuit4With the switch in the RUN position, the meter must show
less than ohmNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector,
or the switch wiring harness Front Drive Selector Actuator NOTE: With the engine stopped and the ignition switch in the ON
position, momentary "whirring" sound must be noticeable each time the selector switch is moved to 2WD and 4WDTest the switch,
30 amp fuse, and wiring connections prior to testing the actuatorNOTE: The differential must be in the unlocked position
for this procedure Front Drive Selector Switch The connector is the two-wire black snap-lock one in front of the steering