2007 Arctic Cat 700 Diesel ATV Service Manual, Page 119Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 119

NOTE: The 4WD icon on the LCD should illuminate 6Connect the red tester lead to the orange wire in the supply harnessThe
be replaced as an assemblyBefore replacing the starter, troubleshoot the starter voltage, starter relay, neutral start, and
start-in-gear relays 3Select the lock position on the differentialThe meter should drop to volts, and the front drive selector
actuator switch should operate to engage 4-wheel driveNOTE: It may be necessary to rock the ATV slightly to engage the differential
lock fullyNOTE: The 4WD and the LOCK icons on the LCD should illuminate To replace the starter, use the following procedureREMOVING
1Remove the negative battery cable from the battery2Remove the left-side inner fender splash panel; then remove the seat
and the left-side engine cover3Disconnect the battery cable and the starter wire from the starter solenoid; then remove the