2007 Arctic Cat 700 Diesel ATV Service Manual, Page 120Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 120

2Connect the battery cable to the starter solenoid; then connect the starter relay wire to the spade terminal on the starter
position, transmission in neutral, brake lock released, and the emergency stop switch in the RUN position 3Depress the starter
button while observing the multimeterThe multimeter should drop to volts and "click" should be heard from the relayNOTE:
If "click" is heard and any voltage is indicated by the multimeter, replace the starter relayIf no "click" is heard and the
multimeter continues to indicate battery voltage, proceed to step 4 4Disconnect the two-wire plug from the starter relay;
then connect the red tester lead to the green wire and the black tester lead to the black wire5Depress the starter button
and observe the multimeterDE653B 3With the starter button depressed, the meter must show battery voltage and the starter
motor should operateNOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect
battery voltage (at the battery), starter motor condition, andor ground connectionsNOTE: If the meter showed no battery voltage,