2007 Arctic Cat 700 Diesel ATV Service Manual, Page 121Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 121

1Using suitable multimeter, select the DC Voltage position; then connect the red tester lead to the positive battery post
battery; then remove the seat and left-side engine cover2Disconnect the battery (B+) wire from the alternator; then disconnect
the voltage regulator control plug-in INSTALLING 1Place the alternatorregulator into position on the engine; then secure
with the existing hardwareDo not tighten at this time2Place the alternator drive belt into position; then using suitable
pry, tension the drive belt so that 10 kg (22 lb) force applied at the midway point will result in deflection of 10-15 mm
(0.4-0.6 in 3Loosen the alternator adjuster cap screw (A) and the pivot bolt (B); then remove the alternator drive beltDE103B
3Holding tension on the belt, tighten the adjuster cap screw securely; then remove the pry and tighten the pivot bolt securely4Connect
the battery (B+) wire and connect the regulator control plug-in; then connect the negative battery cable to the battery5Install