2007 Arctic Cat 700 Diesel ATV Service Manual, Page 122Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 122

Neutral StartFront Drive Actuator Start-in-Gear Differential Lock 2WD Relays The relays are identical plug-in type located
Beam) NOTE: Perform this test on each headlight bulbAlso, 12-volt external power supply wjumpers will be needed 1Set the
meter selector to the DC Voltage position2Connect the red tester lead to the white wire; then connect the black tester lead
to the black wire3With the ignition key in the LIGHTS position, the meter must show battery voltageNOTE: If the meter shows
no voltage, inspect fuses, wiring harness, connectors, and switches VOLTAGE (Brakelight) NOTE: Perform this test on the main
harness side of the connectorAlso, the ignition switch should be in the ON position and the brake (either foot pedal or hand
lever) must be appliedNOTE: Make sure the brake lever (hand) and brake pedal (auxiliary) are properly adjusted for this procedure
1Disconnect the wiring harness from the bulb to be tested2Connect the power supply (positive) to one bulb contact; then connect