2007 Arctic Cat 700 Diesel ATV Service Manual, Page 126Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 126

Front Drive Actuator NOTE: The actuator is not serviceable componentIf it is defective, it must be replacedNOTE: The actuator
side of the actuator INSTALLING 1Lubricate the O-ring on the actuator; then ensure that all mounting surfaces are clean and
free of debris2Align the actuator with the selector shaft and slide it forward onto the shaft taking care to engage the cap
screw in the slot of the front mounting tabAG925 AG926 3Remove the mounting cap screw from below the actuator on the suspension
side 3While holding the actuator firmly forward, tighten the front cap screw to hold the actuator in place; then install
but do not tighten the two remaining cap screws AG928 AG927 4Loosen but do not remove the mounting cap screw at the front
of the actuator; then slide the actuator to the rear enough to clear the slotted mounting tab and the selector shaft 4Loosen