2007 Arctic Cat 700 Diesel ATV Service Manual, Page 134Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 134

Shimming ProcedureShim Selection 1Press bearings into bores by outer ring to hard contact with seat2Install the lock collar
housing to value on the gear case cover; then add 1.5 mm (0.060 inThis will give you the proper shim thicknessNOTE: When
shimming rear gear case, add value to value B BGear Case Sideinstall 1.3-1.4 mm (0.050-0.055 in shim and tighten the bolts
to 3.5-4.3 kg-m (25-31 ft-lb)Verify backlash to be within range of 0.28-0.38 mm (0.011-0.015 in and end-play to be within
range of 0.10-0.20 mm (0.004-0.008 inIf not within specification range, reselect shim until backlash specification range
can be verified4Prior to final assembling, apply molybdenum disulfide grease to all oil seal lips 3Install the pinion gear
assembly into the housingUsing the 48 mm Internal Hex Socket (pn 0444-104), secure the pinion gear assembly with the existing