2007 Arctic Cat 700 Diesel ATV Service Manual, Page 136Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 136

11Making sure the O-ring is properly positioned on the gear case housing, install the housing with existing hardwareAccount
9Install the left bearing housing aligning the match mark to the mark on the differential housing NOTE: Removing the needle
bearing is rarely necessaryAvoid removing the needle bearing unless the bearing is clearly damagedNOTE: This procedure can
be performed on rear gear case 1Place 6.35 mm (14 in drill bit on the inside surface of the needle bearing (against the bottom