2007 Arctic Cat 700 Diesel ATV Service Manual, Page 142Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 142

7Using side-cutters (or suitable substitute), remove both outside boot clamps from the shaftNote the position of the different-sized
approximately 35-55 gramsWhen replacing boots, use 23 of the pack for inside boots and 13 of the pack for outside boots ASSEMBLING
AXLES 1Install the inner boot with the small clamp making sure the ends of the clamp are positioned correctlyNOTE: The boot
is positioned correctly when the small end of the boot seats down into the recessed groove ! CAUTION Do no over-fill the
joint as boot damage may occur resulting in joint failure 9Slide the new outside boot onto the shaft with the new clamps
positioned as shownNote the different-sized clamps from removalNOTE: The boot is positioned correctly when the small end