2007 Arctic Cat 700 Diesel ATV Service Manual, Page 143Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 143

NOTE: Pull the bearing ring out of the housing until it contacts the snap ring; then slide the ring in half wayThis will
To assure proper seating of the axle, give it light pull; the axle should remain "clipped" in place 5Secure the bearing ring
with the snap ring making sure the sharp side of the snap ring faces away from the boot 2Swing the knuckle up and onto the
drive axle; then place the knuckle into place in the upper A-armSecure the knuckle to the A-arm with cap screw and new lock
nutTighten to specifications3Place the hub into position on the axle followed by hex nutTighten the hex nut finger-tight
at this timeCD023 6Making sure the marks made during disassembling align, slide the housing over the bearing ring; then completely
seat the bearing ring into the housing and install the snap ring 4If the brake calipers were removed, position them on the