2007 Arctic Cat 700 Diesel ATV Service Manual, Page 144Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 144

5Compress the hand brake lever; then engage the brake lever lock6Tighten the hub hex nut (from step 3) to specifications;
eyelet to the A-arm with cap screw and new lock nutTighten to specifications3Secure the tie rod to the steering knuckle with
new lock nutTighten securely; then install and spread new cotter pin4Slide the hub wbrake disc into position in the steering
knuckle followed by washer and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckleTighten
to specifications; then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step 4)
to specifications; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut 9Check
the front differential lubricant level and add lubricant as necessary Rear Gear Case REMOVING 1Remove the left-side rear