2007 Arctic Cat 700 Diesel ATV Service Manual, Page 145Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 145

Hub REMOVING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel ! WARNING 4Remove the two cap screws
case into position through the left side of the frame; then secure it to the frame with cap screws and lock nutsTighten to
specificationsNOTE: If new gear case is being installed, tighten the cap screws to 5.1-6.3 kg-m (37-45.5 ft-lb) 2Secure the
engine output shaft to the output shaft coupler with three cap screws (coated with red Loctite #271) and lock nutsTighten
to specifications3Install the rear drive axles (see Drive Axles in this section)4Install the left-side rear A-arms (see Rear
A-Arms in Section 7) 5Remove the hub assembly6Remove the four cap screws securing the brake discCLEANING AND INSPECTING NOTE: