2007 Arctic Cat 700 Diesel ATV Service Manual, Page 154Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 154

7Install the tie rod end and secure with the nutTighten to specifications; then install new cotter pin and spread the pin
2Pump up the hand brake; then engage the brake lever lock3Remove the wheel4Remove the cotter pin securing the hex nut; then
remove the hex nutRelease the brake lever lock5Remove the caliper (right side only)NOTE: Do not allow the brake calipers
to hang from their cablehose 9Secure the hub assembly with the nutTighten only until snug10Secure the brake caliper to the
knuckle with the two cap screws making sure the two 0.76 mm (0.030 in spacer washers are positioned between the caliper and
the knuckleTighten to specifications 6Remove the cap screws and lock nut securing the shock absorber to the frame and lower