2007 Arctic Cat 700 Diesel ATV Service Manual, Page 161Get this manual

2007 Arctic Cat 700 Diesel ATV Service Manual, Page 161

INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Inspect the
handlebar and slide the grip onto the handlebar until it is fully seated3Wipe off any excess glue; then secure the grip with
new rivet4Install the plug on the head of the rivet Steering Knuckles REMOVING AND DISASSEMBLING 1Secure the ATV on support
stand to elevate the wheel; then remove the wheelCD677 ! WARNING Make sure the ATV is solidly supported on the support stand
to avoid injury 7Install the steering post access cover and secure with reinstallable rivets; then install and secure the
radiator access cover 2Remove the wheel cap from the hub; then remove the cotter pin from the nut3Remove the nut securing
the hub4Remove the brake caliper Handlebar Grip REMOVING 1Remove the plug from the head of the rivet2Using 18-indrill bit,
drill out the rivet3Using compressed air between the grip and the handlebar, twist the grip back and forth until it slides
free of the handlebar 5Remove the hub assembly6Remove the cotter pin from the tie rod end and remove the tie rod end from